Advanced Comparative CPU Coin Acceptor with Brushed Aluminum Look Faceplate.

Beautiful CPU coin acceptor with a brushed aluminum look front plate.
The coin acceptor is suitable for all kinds of metal coins and tokens with a diameter of 18~31mm and a thickness of 1.2~3mm.
This coin acceptor uses the example coin principle and is therefore very easy to set up.
Clip the coin of your choice into the comparison slot and the CPU will compare the coins inserted based on this data.
If an abnormality is detected, the CPU will reject the coin and eject it immediately.
The sensitivity (strictness) of acceptance can be adjusted via a rotary control, in case correct coins are also unintentionally refused.

This advanced coin acceptor is also equipped with 2 status LEDs that indicate whether the coin acceptor is clogged, a false/incorrect coin has been inserted or if someone has been "fumbling" with the coin acceptor.

The coin acceptor is equipped with a standard 4-pin JST-XH connector and can be connected directly to a standard JAMMA harness.
If you do not use a JAMMA harness, you can also easily connect the coin acceptor with the supplied cable set.
The coin acceptor works on 12V/DC but the voltage of the outgoing signal can also be lowered with a 5.1V Zener diode
allowing it to be connected to a Raspberry Pi or Arduino.
The possibly required Zener diode can be found here

Technical specifications:
- 12V coin acceptor (with 5.1V Zener diode also suitable for 5V applications)
- 4-pin JST-XH connector
- Selector switch for: NO or NC
- Selector switch for fast, medium, slow coin acceptance
- Adjustable strickt/slack coin acceptance
- Coin counter connection
- Front plate size: 66x125mm
- Installation depth: 116mm

Delivery includes:
1x CPU coin acceptor with brushed aluminum look front plate
1x Mounting set (4x M3 carriage bolt + 4x flange nut)
1x wiring harness (12V/DC, GND, Signal, Counter)

The manual for this article can be found under the photos in 'attachments'