RGB Super Silent Gold-Leaf Concave Classic Arcade Push Button Clear

This Gold Leaf RGB arcade button is a powerful push button with an integrated gold-plated clickless microswitch switch and
equipped with 2.8 mm connections.
Each RGB arcade button has gold plated connectors and comes fully pre-wired.
With a pleasant wire length of 50cm and a 4-pin I / O connector, they are immediately ready to be connected to an Ultimarc PacLED64 or I-PAC Ultimate I / O interface board.

IMPORTANT: The LEDs do not have current-limiting resistors, so MUST be connected to one of the above controllers with current-controlled outputs.
This product is only suitable for 3.3V. When using 5V or 12V, damage will occur due to voltage overload.

Gold-plated contacts
No attack or deterioration does not lead to a deterioration of the response. The contact wings and the external connections are completely gold-plated.

Low inertia
The moving part of the knob is ultra-light and only 10mm deep, unlike other types where the plunger extends the full depth of the knob.

No click
Blade switch means no clicking micro switch.

No plunger spring
The body of the button does not contain a large spring. This results in a uniquely low operating force of 45 grams for the entire button.

No hysteresis
This is the difference in button depression for the contact closure and open points. On these buttons, the position is the same, resulting in maximum repeat activation performance.
With microswitches, this "dead" distance can be up to 1.5 mm.

Concave top
Most serious gamers prefer the classic concave buds over the convex ones commonly used on low-inertia Japanese knobs.

Robust
The button's limit stop is supported by the button body and not the switch, so no chance of damage to the switch from playing too enthusiastically!

Compact integral design
No troublesome installation after installation through the panel. Fully closed blade switch contacts.

Economic
Despite their performance, these are comparable in price to standard arcade buttons and the price is all-inclusive, nothing extra to pay for add-on switch options.

Nut and thread fixing
We have kept the traditional threaded fastening rather than the push-in design of certain other low inertia buttons as we believe this gives the most effective permanent mounting in all types of panels up to 19 mm (3/4 inch) .

RGB lighting
Finally full color RGB lighting without loss of performance!

Pre-wired LEDs
The RGB version has pre-wired dual internal RGB LEDs with 500mm wiring for direct plug-in to our PacLED64 or I-PAC Ultimate I / O cards for dynamic control over all colors.

Connecting your push buttons
These push buttons have tags for 2.8 mm switches
For I-PAC hand-wired connections, we sell packs of 100 crimp connectors
For Mini-PAC pre-made harnesses, select the 2.8 / 4.7mm harness version. This version has 2.8mm on push button connections (excluding Start1,2) and 4.8mm on all other connections
It doesn't matter which tag connects to GND and which one connects to the interface